Swiftcode Elf Hacker by Gaz Minis 75mm Scale (NSFW version available) GM 0345

SCALE DISCLAIMER (from Gaz Minis)

I try to aim for the correct scale for everything I make. However, it is always best to double check scale is consistent with your needs.

NOTE TO BUYER

- Want this in a different scale? Message us for a custom order

- Most if not all images provided are digital renders of the models. For more photos of actual prints visit our Instagram page on https://www.instagram.com/3denprints/

- All models will be dispatched unpainted. Some models may require further assembly using superglue.

- The Scaling of the model is typically eyeline to toe height of an average human at this scale. This is not the actual height of the model. Please refer to the scale images depicting the model alongside a cm ruler

- All supports have been removed and models have been washed and cured. Due to the nature of the resin printing process, some supports are required and will occasionally leave marks on the model's surface. We do our utmost to ensure that these are kept to a minimum and are easily rectified by a little sanding.

Resin used:
Prints will be in standard grey resin but in the event that we run out of stock, we will use an alternative colour.

We are officially licensed to sell the prints made by Gaz Minis:
Gaz Minis @Gaz_Minis - MyMiniFactory

Gaz Minis | creating 3D Printable Character Minis and Figurines | Patreon

If you have any issues with your order please contact us. We would much rather send out a replacement than receive negative feedback!
Many thanks for supporting our small business!

Please follow us on

Instagram: https://www.instagram.com/3denprints/

Facebook: www.facebook.com/3denprints

Etsy: www.etsy.com/uk/shop/3DenResinPrints